C-TOP+ can be installed to any current process valve in the food-processing, beverage and biopharmaceutical industries.
Operating principle
C-TOP+ can be installed to any current process valve in the food-processing, beverage and biopharmaceutical industries.
Operating principle
The C-TOP+ control unit incorporates indication and command devices to control pneumatically operated process valves.
This unit as a single piece has the following features:
• Pneumatic and electric control over the valve
• Position sensors with feedback
The control units are fitted to the pneumatic actuator. It receives signals from a control panel or from a PLC to actuate the valves and sends signals to the PLC or to the control panel to communicate the status/position of the valve.
C-TOP+ unit contains three LEDs (depending on the configuration) constantly indicating the operating status of the valve. A fourth LED (white) indicates whether the operating voltage supply is connected.
Design and features
The design of the C-TOP+ unit is simple, modular and resistant that guarantees the maximum flexibility. Depending on the product version it has up to three 3/2 solenoid valves (NC) and three sensors. If necessary, an additional external sensor and an additional external solenoid valve can be connected.
The sensors are actuated contact-free by a magnet attached to the control rod. The sensor can be magnetoresistive or magnetic reed type and it is activated without contact wiith a magnet in the shaft control.
The C-TOP+ units can be set up according to the customer’s requirements.
Materials
End cap: Polypropylene
Housing: Reinforced polypropylene
Plate: Reinforced polypropylene
Seals: EPDM
Screws: Stainless steel
